How much is the vape atomizer plug cotton?

In the daily use of vape, it has been a matter of debate about how cotton is stuffed into the fever wire. Some people like to put the cotton plugs very tight, and some people like to push the cotton into the circle of the heating wire repeatedly, this yellow will say how much cotton is suitable.

We often say the word remedy, then in the use of cotton, we start with Rebuild drip atomizer (RDA), Rebuild drip atomizer can be directly dripped on the heating wire and cotton when adding e-liquid . In daily use, I often listen to my friends around me. I have to pump two pieces of cotton to drip oil. Some friends say that my cotton has a large amount of oil. Therefore, when plugging cotton, Rebuild drip atomizer does not have to think too much about the speed of the oil. The looseness and tightness of cotton directly affect the frequency of filling e-liquid. The cotton storage capacity is small, the number of sucking mouth is small, the cotton is tightly stored, and the number of mouths is much.

Because the Rebuild tank atomizer (RTA) needs to guide the oil through the small hole inside the oil storage tank when guiding the oil, the oil guiding speed is slower than that of the Rebuild drip atomizer. When you stuff cotton, you must avoid the oil that is too tight and the oil is too tight. Otherwise, it can be a sour taste. One of the most common words that my friend girl gave to DIY Rebuild tank atomizer was that my cotton could dance in the circle of the hot wire.

In addition to the above two atomizers, some players also use the Rebuild drip tank atomizer (RDTA). Because this atomizer works like the Rebuild tank atomizer, it conducts oil through the corners of both ends of the cotton. So when we are stuffing cotton, we need to be as tight as the Rebuild tank atomizer. Otherwise, the sour taste will come again.

For players who like low-resistance and high-power, I personally recommend that the cotton plugs be more secure. This method increases the oil storage and reduces the e-liquid evaporation on the cotton under high power. It is too early. Dry out. If it is high resistance and low power, cotton can be loosened. After all, the power is small, and the e-liquid evaporation rate will not be so fast. After the cotton is plugged, the ends of the cotton need to be loosened with tools, which is beneficial to increase the oil guiding of the cotton and is suitable for any kind of atomizer. You can also share the experience of plugging cotton in the article message section.

"Hangboo is a leading e-liquid manufacturer and e-liquid supplier with factory locations in Guangdong Province, China. We provide Wholesale e-liquid and OEM e-liquid businesses worldwide."

Prev:Russian Minister of Health supports vape Next:Is the old man suitable for vaping Vape?