How to add e-liquid to vape

A vape is an electronic device that converts specially prepared e-liquid into vapor through an electronically heated atomizer. Due to its health, environmental protection, no second-hand smoke and other advantages, vape is gradually becoming more and more popular. However, for beginners to vaping, how to add e-liquid can be a confusing question. There are different types of vape, and there are also different types of atomizers (Atomizers). They have different ways of adding e-liquid. Let’s introduce them below.

First. High-power vape

1. Rebuild drip atomizer

For Rebuild drip atomizer, you first need to unscrew the cap of the atomizer, and then drip e-liquid onto the oil-conducting cotton. Wait until the oil-conducting cotton is completely soaked and there is still a little overflow. If you add too much, it will easily occur. Oil leakage. If the inhalation is deep or the power is relatively high, usually you need to add e-liquid again after five or six puffs.

2. Rebuild tank atomizer

For Rebuild tank atomizer, you need to take out the atomizer tank and pour in the appropriate amount of e-liquid. Generally speaking, Rebuild tank atomizer has a larger capacity and can accommodate more e-liquid. It is recommended not to exceed the maximum capacity when adding e-liquid to avoid waste or affecting the taste.

Second. Low power vape

1. Ego-type open Atomizer

The method of adding e-liquid to the ego-type open Atomizer is relatively simple. First, you need to take out the Atomizer and then add an appropriate amount of e-liquid inside it. It is recommended to use e-liquid that matches Atomizer to ensure taste and safety. Finally, reinstall the Atomizer into the vape and wait for a minute or two for the atomizer core to be completely infiltrated before use.

2. Closed Atomizer

The closed Atomizer of low-power vape is the consistent practice of the original Atomizer, because this can ensure the best taste and make more money. This Atomizer is completely closed, and it is a bit difficult to add e-liquid. At this time, it is necessary Use a drill bit to drill a hole in the upper part of the oil tank, and then inject e-liquid. If conditions permit, it is best to plug the hole with a rubber plug. These tools are sold in sets online. Because Atomizers all have the disadvantage of carbon accumulation, it is best to add e-liquid 3-4 times to a closed Atomizer before it can be used again.

3. Compatible open Atomizer

For the compatible open Atomizer, it is very simple to add the Atomizer because it has a dedicated oil filling port. However, it should be noted that after adding the e-liquid, it should be left for a few minutes to allow the e-liquid to fully moisturize the atomizer core. before use, otherwise the core may become sticky. The lifespan of the open Atomizer has a great relationship with the e-liquid you use, so it is best not to add too much e-liquid at one time to avoid unnecessary waste.

Third. Suggestions on adding e-liquid

1. Do not add too much e-liquid. Too much e-liquid may affect the taste and safety.

2. Do not add too little e-liquid. Too little e-liquid may result in insufficient atomization or poor taste.

3. Do not use e-liquid brands or types that are incompatible with the vape to avoid causing damage to the vape or affecting the taste.

4. After adding e-liquid, make sure to keep the vape properly to prevent children or pets from accidentally eating or inhaling it.

5. If you find any abnormality or smell in your vape, you should stop using it immediately and seek professional help.

Adding e-liquid correctly is an important part of using vape. Different types of vape and atomizer have different adding methods, so you should read the instructions carefully and follow the instructions before use. At the same time, in order to ensure the safety and taste of the vape, it is recommended to use the e-liquid brand and type that matches the vape.