The problem with the finished Atomizer

For new users of vapes, various problems of DIY vape Atomizer plagued users and affected users' interest in DIY. Perhaps you will think of the finished Atomizer at this time, then, will the finished Atomizer not have these problems?

The excellent finished Atomizer will be less or lighter than the DIY Atomizer, but it is still a structural problem. These problems are inevitable because of the cost of Atomizer. What are the problems with the cost of Atomizer? Let's talk about it.

1, the finished product Atomizer will also leak oil

At present, the mainstream Atomizer products are all equipped with a convenient top oil filling structure. If the bottom air intake is not closed during the oil filling operation, the warehouse pressure is unbalanced, and oil leakage may occur. At the same time, if the user blows the inside of the finished Atomizer and the blowing force is large, the E-liquid in the tank is also pressed out. To ensure proper oil filling and Atomizer usage, oil spills are easy to avoid.

2, the finished Atomizer will also produce condensate

Condensate is actually produced when all Atomizers are used. It can even be said that condensate is a technical problem that Atomizer cannot currently overcome. Although unavoidable, it is still possible to reduce the rate of condensate production. When using the Atomizer, be careful to loosen the ignition key for air inhalation before the end of inhalation, and all the residual smoke in the flue can be sucked out to prevent the smoke from generating condensate in the flue.

3, the finished Atomizer still has the problem of Frying Oil

The instantaneous heating of the coil causes the E-liquid to splatter and produce a squeaking sound, and the low temperature condensate returns to the atomizing core, which further aggravates the Frying Oil condition. Control the output power of the output device, do not use too high power for ignition, can make the heating of the coil more stable, avoid the situation of Frying Oil in the atomizing core by instantaneous heating, and pay attention to reduce the speed of condensate production, it can also be very effective Control the emergence of Frying Oil.

4, the finished Atomizer will deteriorate after a period of use

When the finished Atomizer is used for a period of time, there is often a situation where the amount of smoke is reduced and the taste experience is deteriorated. This is caused by the carbonization of the inner coil of the atomizing core and the aging of the atomizing core caused by the contamination of the cotton. When the finished Atomizer has a bad taste, the amount of smoke is attenuated or even smelly, the user needs to replace the finished core in time to solve the problem.

5, the atomization core aging is easy to accelerate

Many of the atomized cores of the finished Atomizer are not capable of high-speed conduction of VG high E-liquid or pure VG. If high VGE-liquid is used in the finished Atomizer and high frequency suction, the atomizing core will be very It is burning soon. At the same time, the use of E-liquid with higher carbon content will also accelerate the carbonization of the finished core. Exceeding the matching power of the finished core, the probability of the atomized core burning is greatly increased. In order to ensure the normal life of the finished product core, it is necessary to pay attention to the appropriate E-liquid in the matching power.

When using the finished Atomizer, users need to pay attention to the correct method of filling and usage. To ensure the normal service life of the atomizing core, and at the same time reduce the production speed of the Atomizer condensate by air suction, and replace the atomizing core in time when the atomizing core is aging, so that the normal use of the finished Atomizer can be ensured. Brings excellent mouthfeel and smoke performance.

Prev: Seasoning E-liquid may cause teens to become... Next:Vape into the cockpit hidden behavior?